2 June 2021 in Nature Communications
Dielectric metasurfaces support resonances that are widely explored both for far-field wavefront shaping and for near-field sensing and imaging. Their design explores the interplay between localised and extended resonances, with a typical trade-off between Q-factor and light localisation; high Q-factors are desirable for refractive index sensing while localisation is desirable for imaging resolution. Here, we show that a dielectric metasurface consisting of a nanohole array in amorphous silicon provides a favourable trade-off between these requirements. We have designed and realised the metasurface to support two optical modes both with sharp Fano resonances that exhibit relatively high Q-factors and strong spatial confinement, thereby concurrently optimizing the device for both imaging and biochemical sensing. For the sensing application, we demonstrate a limit of detection (LOD) as low as 1 pg/ml for Immunoglobulin G (IgG); for resonant imaging, we demonstrate a spatial resolution below 1 µm and clearly resolve individual E. coli bacteria. The combined low LOD and high spatial resolution opens new opportunities for extending cellular studies into the realm of microbiology, e.g. for studying antimicrobial susceptibility.
2 June 2020 in Light: Science & Applications
Research toward photonic biosensors for point-of-care applications and personalized medicine is driven by the need for high-sensitivity, low-cost, and reliable technology. Among the most sensitive modalities, interferometry offers particularly high performance, but typically lacks the required operational simplicity and robustness. Here, we introduce a common-path interferometric sensor based on guided-mode resonances to combine high performance with inherent stability. The sensor exploits the simultaneous excitation of two orthogonally polarized modes, and detects the relative phase change caused by biomolecular binding on the sensor surface. The wide dynamic range of the sensor, which is essential for fabrication and angle tolerance, as well as versatility, is controlled by integrating multiple, tuned structures in the field of view. This approach circumvents the trade-off between sensitivity and dynamic range, typical of other phase-sensitive modalities, without increasing complexity. Our sensor enables the challenging label-free detection of procalcitonin, a small protein (13 kDa) and biomarker for infection, at the clinically relevant concentration of 1 pg mL−1, with a signal-to-noise ratio of 35. This result indicates the utility for an exemplary application in antibiotic guidance, and opens possibilities for detecting further clinically or environmentally relevant small molecules with an intrinsically simple and robust sensing modality.
8 August 2017 in Scientific Reports
Concepts for information storage and logical processing based on magnetic domain walls have great potential for implementation in future information and communications technologies. To date, the need to apply power hungry magnetic fields or heat dissipating spin polarized currents to manipulate magnetic domain walls has limited the development of such technologies. The possibility of controlling magnetic domain walls using voltages offers an energy efficient route to overcome these limitations. Here we show that a voltage-induced uniaxial strain induces reversible deterministic switching of the chirality of a magnetic vortex wall. We discuss how this functionality will be applicable to schemes for information storage and logical processing, making a significant step towards the practical implementation of magnetic domain walls in energy efficient computing.
7 April 2026 in Biosensors and Bioelectronics
Complex diseases arise from networks of interacting biomolecules, yet most analytical technologies measure only a limited number of interactions simultaneously. Here, we present a chirped guided-mode resonance (cGMR) photonic biosensor array for multiplexed, label-free analysis of biomolecular kinetics across hundreds of sensing sites. The platform integrates 322 photonic sensors on a single chip that are fabricated using a CMOS process ensuring high reproducibility (wavelength sensitivity of 36.8 pixels/nm with a standard deviation of 1.37 pixels/nm). Shifts in the photonic resonance due to molecular binding are recorded using a conventional CMOS camera allowing time-resolved and simultaneous measurements across the entire array. We demonstrate the platform's versatility by monitoring real-time binding of antibodies, aptamers, and synthetic glycopolymers where the parallel measurements reveal distributions of binding responses arising from surface heterogeneity and multivalency that are inaccessible to conventional, single biosensor platforms. As a model, wheat germ agglutinin binding to a GlcNAc-displaying glycopolymer yielded sub-micromolar equilibrium dissociation constants (KD = 28-564 nM). Crucially, the array successfully resolves the kinetics of lectin-glycopolymer binding interactions using a portable optical setup, even in a complex biological matrix. By combining scalable CMOS fabrication with portable, highly parallel interrogation, this cGMR array provides a robust route toward high-throughput biomolecular profiling in point-of-care diagnostics and drug discovery.
18 June 2019 in IEEE Photonics Journal
Light trapping has now been recognised as an essential element of highly-efficient solar cells. A large number of sophisticated nanostructures have been developed and optically characterised, many of which have been aimed at thin film silicon technology. It is still an open question whether such nanostructures are beneficial for thick devices, however, especially since highly efficient solar cells employ >100 μm thick absorber materials and wet etched micron-sized pyramids for light trapping. Here, we study and compare the optical and electrical performances of binary quasi-random nanostructures with pyramidal structures to address this question. We show that, while simulations indicate that pyramids have better optical performance, the best overall performance observed experimentally was achieved with binary nanostructures. We found that the experimental short circuit current for a solar cell patterned with a quasirandom nanostructure is 3.2 mA/cm2 higher than the current observed with pyramids. We attribute this higher current to a better balance between optical performance and surface recombination achieved by the binary nanostructures. This result indicates that binary nanostructures may be beneficial even for thick solar cells.