Cecilia Gimeno

Cecilia Gimeno

Auto-generated profile, based on publicly available information

Cecilia Gimeno

ICTEAM Institute, Université catholique de Louvain (UCLouvain), Louvain-la-Neuve, Belgium

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 November 2017 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
CGCecilia Gimeno
Cecilia Gimeno
Denis FlandreDenis Flandre
Denis Flandre
David BolDavid Bol
David Bol
This paper presents the system architecture, modeling, and design constraints of a wireless chip-to-chip-communication transceiver as a low-power alternative to wireline links, such as PCI-Express. On top of the potential power savings, the wireless link provides lower latency times, better flexibility, lower complexity, and easier heat diffusion. The proposed transceiver uses impulse-radio ultra-wideband communication at 10 GHz. It supports a 2.5-Gb/s data rate with pulse position modulation over short distances (~10 cm). The hardware complexity is reduced by using a modified non-coherent receiver with a rectifying RF front-end and a relative-compare analog baseband. The system performance is quantified and tradeoffs are explored with the main motivation of reducing power. A discussion of the modulation choice, the performance specifications of the receiver blocks and the clock generation principle is presented. We show that energy efficiency better than 6 pJ/bit could be reached with the proposed architecture.

30 December 2016 in Sensors
Verified
Journal Article
Open access
PDF file
GRGuillermo Royo
Guillermo Royo
CSCarlos Sanchez-Azqueta
Carlos Sanchez-Azqueta
CGCecilia Gimeno
Cecilia Gimeno
CAConcepción Aldea
Concepción Aldea
SCSantiago Celma
Santiago Celma
In this work, we present a capacitance-to-voltage converter (CVC) for capacitive accelerometers based on microelectromechanical systems (MEMS). Based on a fully-differential transimpedance amplifier (TIA), it features a 34-dB transimpedance gain control and over one decade programmable bandwidth, from 75 kHz to 1.2 MHz. The TIA is aimed for low-cost low-power capacitive sensor applications. It has been designed in a standard 0.18-μm CMOS technology and its power consumption is only 54 μW. At the maximum transimpedance configuration, the TIA shows an equivalent input noise of 42 fA/ Hz at 50 kHz, which corresponds to 100 μg/ Hz .

1 May 2017
Verified
Conference Paper
Closed access
GRGuillermo Royo
Guillermo Royo
MGMiguel Garcia-Bosque
Miguel Garcia-Bosque
CSCarlos Sanchez-Azqueta
Carlos Sanchez-Azqueta
CAC. Aldea
C. Aldea
SCSantiago Celma
Santiago Celma
CGC. Gimeno
C. Gimeno
In this work, a capacitance-to-voltage converter based on a fully-differential transimpedance amplifier (TIA) with programmable gain and bandwidth for MEMS accelerometers is presented. It is aimed for a differential surface-micromachined comb-finger capacitive accelerometer, but can be used in many other capacitive sensor applications. The TIA has been designed in a 180-nm CMOS technology and it achieves a minimum equivalent input noise of 42 fA/√Hz at 50 kHz, which corresponds to an acceleration noise of 100 μg/√Hz.

23 April 2018 in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
Verified
Journal Article
Closed access
CGCecilia Gimeno
Cecilia Gimeno
David BolDavid Bol
David Bol
Denis FlandreDenis Flandre
Denis Flandre
In this brief, a half-rate (HR) bang-bang (BB) phase detector (PD) with multiple decision levels is proposed for clock and data recovery (CDR) circuits. The combination allows the oscillator to run at half the input data rate while providing information about the sign and magnitude of the phase shift between the PD inputs. This allows a finer control of the frequency of the oscillator in the phase-locked loop (PLL) of the CDR circuit, which results in up to 30% less output clock jitter than with a conventional two-levels HR BB PD. Thanks to this, the bit error rate can be decreased by up to 5x in a 5-Gb/s CDR circuit. The proposed topology was implemented in a 28-nm FDSOI CMOS technology providing average power consumption below 76 μW with a supply voltage of 1 V. Although multilevel (ML) BB PDs have already been proposed in some PLL-based CDR with very interesting results, a specific design of the PD has to be implemented for an HR system. This brief provides the first ML-HR-BBPD.

16 February 2017 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
CGC. Gimeno
C. Gimeno
EGE. Guerrero
E. Guerrero
CSC. Sanchez-Azqueta
C. Sanchez-Azqueta
JAJ. Aguirre
J. Aguirre
CAC. Aldea
C. Aldea
SCS. Celma
S. Celma
This letter presents a novel adaptive continuous-time equalizer integrated in a receiver front-end for short-reach high-speed optical communications through low-cost step-index plastic optical fibers (SI-POF). The proposed equalizer is able to compensate the variations in the frequency response and attenuation of a 1-mm diameter SI-POF but it is also able to work at different data rates ranging from 400 Mb/s to 2.5 Gb/s. The prototype has been integrated in a cost-effective standard 0.18-μm CMOS technology, and requires 60 mW of power consumption under just 1-V supply voltage.

1 January 2019
Verified
Conference Paper
Open access
PDF file
CSCarlos Sánchez-Azqueta
Carlos Sánchez-Azqueta
ECEsther Cascarosa
Esther Cascarosa
SCSantiago Celma
Santiago Celma
CGCecilia Gimeno
Cecilia Gimeno
CAConcepción Aldea
Concepción Aldea
- Las tecnologías de información y la comunicación (TICs) son un instrumento privilegiado para promover y facilitar el aprendizaje significativo de los alumnos ya que se basan en el aumento de la motivación. El uso de recursos multimedia y entornos virtuales de aprendizaje ya ha sido adoptado en numerosas instituciones de educación superior como parte de un proceso de aprendizaje mixto. En este trabajo se describe una acción de intervención en el aula basada en Recursos Educativos de libre Acceso (REA) con dos fases de actuación claramente diferenciadas. En la primera se ha llevado a cabo un proceso de identificación de conceptos físicos de difícil comprensión para los alumnos, seguido de un análisis de los resultados obtenidos de dicho diagnóstico. Posteriormente se ha realizado una intervención en el aula que persigue mejorar la compresión de dichos conceptos eligiendo la metodología más adecuada en función de las dificultades que se derivaron del primer análisis. Una de las metodologías propuestas es la actualización del concepto de tutoría académica mediante la realización de un canal de YouTube para alojar videotutoriales o píldoras electrónicas de refuerzo. Sánchez-Azqueta, Carlos; Cascarosa, Esther; Celma, Santiago; Gimeno, Cecilia; Aldea, Concepción