23 October 2009 in Accreditation and Quality Assurance
1 November 1998 in Measurement Science and Technology
1 February 2019 in Journal of Atmospheric and Oceanic Technology
This article describes the interlaboratory comparison (ILC) of meteorological and hydrological calibration laboratories in the field of temperature (−30° to 40°C), humidity (10%–95% RH at room temperature), and pressure (800–1100 hPa). The ILC was organized by the World Meteorological Organization (WMO) Regional Instrument Centre (RIC) at the Slovenian Environment Agency and University of Ljubljana, Faculty of Electrical Engineering, Laboratory of Metrology and Quality as an accredited interlaboratory comparison (proficiency testing) provider according to the ISO/IEC 17043:2010 standard. The ILC was organized in the target area of WMO Regional Association VI (Europe). The protocol and procedure for ILC were developed within European Metrology Research Project (EMRP) MetoMet2. The participants used their standardized procedures for calibration. Because of the large number of participating laboratories (18) from 17 countries, the ILC was organized in two loops, which were linked via four linking laboratories and evaluated using the En number. The equipment used in both loops exhibited stability and uncertainty, which enabled evaluation of the laboratories’ capabilities. The article presents the data processing, the linkage procedure, and the main results for all three categories (temperature, humidity, and pressure). It was observed that some of the laboratories had unusually low uncertainties. From the metrological point of view, the authors present some comments and suggestions to the laboratories, the results of which differ from the reference ones. The conclusions can help also other meteorological laboratories and organizations that did not participate in the ILC with their everyday work.
25 September 2009 in Instrumentation Science & Technology
Accurate and repeatable spatial positioning of measurement equipment is required in many laboratory experiments and measurement procedures. Although such mechanical manipulation can often be performed manually, by using special equipment such as different mechanical tripods, an automated spatial positioning system offers several advantages, such as higher accuracy and repeatability, reduced operator workload, and possibility to implement more complex measurement procedures. Many adequate spatial positioning systems are commercially available, but our aim was to produce a high quality, low cost, and measurement oriented solution, with special emphasis on correct evaluation of all metrological parameters.