Nadeemullah A. Mahadik

Nadeemullah A. Mahadik

Auto-generated profile, based on publicly available information

Nadeemullah A. Mahadik

U.S. Naval Research Laboratory

Research Focus & Metrics

Academic Career Length

20Years (2007-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
14 September 2015 in Crystal Growth & Design
Verified
Journal Article
Closed access
JFJaime A. Freitas
Jaime A. Freitas
JCJ. C. Culbertson
J. C. Culbertson
NMN. A. Mahadik
N. A. Mahadik
TSTomasz Sochacki
Tomasz Sochacki
MBM. Bockowski
M. Bockowski
MIMalgorzata Iwinska
Malgorzata Iwinska

1 December 2018
Verified
Conference Paper
Closed access
RSR. E. Stahlbush
R. E. Stahlbush
NMN. A. Mahadik
N. A. Mahadik
ALA. J. Lelis
A. J. Lelis
RGR. Green
R. Green
As silicon carbide power devices enter the commercial power electronics market there is a strong interest in all aspects of their reliability. This work discusses the degradation of MOSFETs due to basal plane dislocations (BPDs). During the forward bias of the MOSFET body diode, electron-hole recombination causes BPDs to fault and the resulting stacking faults in the drift layer degrade the MOSFET. As the stacking faults grow, the on-state conductivity of the MOSFET drift layer decreases, the off-state leakage of the drift layer increases, and the forward voltage of the body diode increases. Commercial 1200 V MOSFETs were stressed with a body current of 5 A or 10 A. The first generation of commercial MOSFETs showed significant degradation within minutes of stress time, whereas more recent MOSFETs did not show degradation for over 5 hours of stress time.

2 December 2014 in Crystal Growth & Design
Verified
Journal Article
Closed access
NMN. A. Mahadik
N. A. Mahadik
SQS. B. Qadri
S. B. Qadri
JFJr. J. A. Freitas
Jr. J. A. Freitas

27 November 2017 in Applied Physics Letters
Verified
Journal Article
Closed access
NMNadeemullah A. Mahadik
Nadeemullah A. Mahadik
RSRobert E. Stahlbush
Robert E. Stahlbush
PKPaul B. Klein
Paul B. Klein
AKAni Khachatrian
Ani Khachatrian
SBStephen Buchner
Stephen Buchner
SBSteven G. Block
Steven G. Block
Carrier lifetime control in thick silicon carbide (SiC) epilayers is essential for fabricating >10 kV devices. Lifetime depth profiles were investigated in n-type and p-type SiC epilayers using photoluminescence (PL) decay excited by two-photon absorption (TPA), using 586 nm laser pulses. TPA limits the excitation to a small volume, and the observed PL decays exhibit nonexponential behavior resulting from the three-dimensional carrier diffusion occurring during the decay. The results were analyzed using a formalism that includes the effects of carrier lifetime, carrier diffusion, and surface recombination on the PL decay. The lifetime depth profiles exhibited a nonuniform lifetime-degrading defect concentration within the epilayers.

2 July 2020 in Scientific Reports
Verified
Journal Article
Open access
PDF file
NMNadeemullah A. Mahadik
Nadeemullah A. Mahadik
HDHrishikesh Das
Hrishikesh Das
SSStanislav Stoupin
Stanislav Stoupin
RSRobert E. Stahlbush
Robert E. Stahlbush
PBPeter L. Bonanno
Peter L. Bonanno
GRGary E. Ruland
Gary E. Ruland
Lattice distortions (LD) in 4H-silicon carbide (SiC) wafers were quantified using synchrotron X-ray rocking curve mapping (RCM), and were resolved into their two components of lattice strain (Δd/d) and lattice plane curvature (LPC) for 150 mm diameter wafers. The evolution of these LDs were investigated for three sequential substrates from the same boule, one of which was the substrate reference, and the other two had a 10 µm thick, 1 × 1017 and 4 × 1014 cm-3 n-type doped epitaxial layer. The lattice strain, Δd/d, was highest for the lowest doped wafer due to higher mismatch with the substrate wafer. After epitaxial layer growth, the LPC variation across the wafer increases by a factor of 2, irrespective of doping. The LPC maps indicate presence of a twist in the lattice planes that increases after epitaxial growth. The LPC component has higher influence on wafer shape change, which can reduce device yields. The lattice strain component predominantly affects the glide of basal plane dislocations (BPDs), thereby reducing device reliability. From analysis of peak widths, it was determined that threading dislocations in the top 6 microns of the wafer increase after epitaxial layer growth.

18 August 2023 in Journal of Applied Physics
Verified
Journal Article
Open access
PDF file
SHSami A. El Hageali
Sami A. El Hageali
HGHarvey Guthrey
Harvey Guthrey
SJSteve Johnston
Steve Johnston
ANAndrew Norman
Andrew Norman
JSJake Soto
Jake Soto
MAMowafak Al-Jassim
Mowafak Al-Jassim
To this day, trapezoidal defects are found in clusters and high counts in wafers representing the industry standard in terms of material quality being produced. This study sheds light on the nature, origin, behavior, and impact of this defect on device yield and reliability. Trapezoidal defects in 4H-SiC epitaxial layers were investigated by photoluminescence (PL) imaging, scanning electron microscopy (SEM), cathodoluminescence spectrum imaging (CLSI), SEM electron beam induced current (EBIC) imaging, and by transmission electron microscopy (TEM) observation. The bar-shaped stacking faults were identified by the PL and CL measurements with a peak emission wavelength of 420 and 450 nm. An optoelectronic behavioral study based on the recombination enhanced dislocation glide mechanism revealed how expanding dislocations and stacking faults interact with each other. Combining the luminescence and microscopy results, the nature of the stacking faults was identified as being a combination of Shockley-type and Frank-type stacking faults. The TEM analysis showed that these defects originate from the substrate and the stacking sequences of some of the faults were determined as (…2, 4, 2…) and (…2, 3, 2…) in the Zhdanov's notation by high-resolution TEM. The origin of this defect is speculated based on our results and previous reports. The EBIC imaging showed that the high density of SFs in these towers is a strong site of carrier recombination, which presumably has an impact on the transfer characteristics of SiC devices. Furthermore, these defects have shown to impact metal oxide semiconductor field effect transistors electrical performance via an increase in the on-state resistance depending on the coverage percentage of the tower of defects in the active area of the device.