James C. Culbertson

James C. Culbertson

Auto-generated profile, based on publicly available information

James C. Culbertson

U.S. Naval Research Laboratory 1 , Washington, District of Columbia 20375

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
14 September 2015 in Crystal Growth & Design
Verified
Journal Article
Closed access
JFJaime A. Freitas
Jaime A. Freitas
JCJ. C. Culbertson
J. C. Culbertson
NMN. A. Mahadik
N. A. Mahadik
TSTomasz Sochacki
Tomasz Sochacki
MBM. Bockowski
M. Bockowski
MIMalgorzata Iwinska
Malgorzata Iwinska

2 March 2009 in Materials Science Forum
Verified
Journal Article
Open access
PDF file
BVBrenda L. VanMil
Brenda L. VanMil
RMRachael L. Myers-Ward
Rachael L. Myers-Ward
JTJoseph L. Tedesco
Joseph L. Tedesco
CECharles R. Eddy
Charles R. Eddy
GJGlenn G. Jernigan
Glenn G. Jernigan
DGD. Kurt Gaskill
D. Kurt Gaskill
Graphene layers were created on both C and Si faces of semi-insulating, on-axis, 4H- and 6H-SiC substrates. The process was performed under high vacuum (<10-4 mbar) in a commercial chemical vapor deposition SiC reactor. A method for H2 etching the on-axis substrates was developed to produce surface steps with heights of 0.5 nm on the Si-face and 1.0 to 1.5 nm on the C-face for each polytype. A process was developed to form graphene on the substrates immediately after H2 etching and Raman spectroscopy of these samples confirmed the formation of graphene. The morphology of the graphene is described. For both faces, the underlying substrate morphology was significantly modified during graphene formation; surface steps were up to 15 nm high and the uni-form step morphology was sometimes lost. Mobilities and sheet carrier concentrations derived from Hall Effect measurements on large area (16 mm square) and small area (2 and 10 m square) samples are presented and shown to compare favorably to recent reports.

15 May 2009 in ECS Transactions
Verified
Journal Article
Open access
PDF file
JTJoseph L. Tedesco
Joseph L. Tedesco
BVBrenda VanMil
Brenda VanMil
RMR. L. Myers-Ward
R. L. Myers-Ward
JCJames Culbertson
James Culbertson
GJGlenn Jernigan
Glenn Jernigan
DGD. K. Gaskill
D. K. Gaskill
Graphene was epitaxially grown on both the C- and Si-faces of 4H- and 6H-SiC(0001) under an argon atmosphere and under high vacuum conditions. Following growth, samples were imaged with Nomarski interference contrast and atomic force microscopies and it was found that growth under argon led to improved morphologies on the C-face films but the Si-face films were not significantly affected. Free carrier transport studies were conducted through Hall effect measurements, and carrier mobilities were found to increase and sheet carrier densities were found to decrease for those films grown under argon as compared to high vacuum conditions. The improved mobilities and concurrent decreases in sheet carrier densities suggest a decrease in scattering in the films grown under argon.

1 August 2025 in APL Materials
Verified
Journal Article
Open access
Marko Jak TadjerMarko Jak Tadjer
Marko Jak Tadjer
KHKenny Hyunh
Kenny Hyunh
JCJames C. Culbertson
James C. Culbertson
EGEvan Richard Glaser
Evan Richard Glaser
MLMichael Liao
Michael Liao
KHKarl D. Hobart
Karl D. Hobart
Homoepitaxial Si-doped (010) β-Ga2O3 epitaxial layers with thicknesses ranging from 1.2 to 12 μm were grown simultaneously via close-injection showerhead metal-organic chemical vapor deposition on both Czochralski and edge-defined, film-fed grown (010) β-Ga2O3:Fe substrates. Structural characterization was performed via x-ray diffraction [full-width at half maxima of 21–72 arcsec depending on epilayer thickness and substrate, measured from the symmetric (020) reflection], x-ray topography, Raman spectroscopy, cathodoluminescence spectroscopy, and transmission electron microscopy. Surface characterization was performed via atomic force microscope (AFM) and Nomarski imaging, and electrical characterization was performed via electron paramagnetic resonance spectroscopy and Hall effect measurements. In addition, thermal conductivity was measured via steady-state thermoreflectance. AFM imaging revealed a number of extended defects forming in the epilayer, and transmission electron microscopy imaging detailed a V-shaped pit defect formed by misoriented twin defects likely originating from a defect at or near the substrate surface. The Hall effect data (NS = 2.81–3.1 × 1017 cm−3 and μH = 81.5–103.5 cm2/V s), surface roughness (1.78–4.25 nm rms), and thermal conductivity measurements (19.3–19.8 W/m K) yielded comparable results among all samples, independent of epilayer thickness. These results suggested that even thicker, high quality epitaxial (010) β-Ga2O3 could be grown via this technique, provided that the development of the observed extended defects can be mitigated.

14 September 2022 in Crystals
Verified
Journal Article
Open access
PDF file
JFJaime A. Freitas
Jaime A. Freitas
JCJames C. Culbertson
James C. Culbertson
EGEvan Richard Glaser
Evan Richard Glaser
GaN and its alloys with InN and AlN are of technological importance for a variety of optical, electronic, and optoelectronic devices due to its high thermal conductivity, wide band gap, high breakdown voltage and high saturation velocity. GaN-based devices now provide superior performance for a variety of high power, high frequency, high temperature, and optical applications. The major roadblock for the full realization of Nitride semiconductor potential is still the availability of affordable large-area and high-quality native substrates with controlled electrical properties. Despite the impressive accomplishments recently achieved by techniques such as hydride vapor phase epitaxy and ammonothermal for GaN growth, much more must be attained before establishing a fully satisfactory bulk growth method for this material. Recent results suggest that ammonothermal GaN wafers can be successfully used as seeds to grow thick freestanding GaN wafers by hydride vapor phase epitaxy. A brief review of defect-sensitive optical and paramagnetic spectroscopy techniques employed to evaluate structural, optical, and electronic properties of the state-of-the-art bulk and thick-film (quasi-bulk) Nitride substrates and homoepitaxial films is presented. Defects control the performance of devices and feeding back knowledge of defects to growth efforts is key to advancing technology.

4 December 2023 in Journal of Applied Physics
Verified
Journal Article
Open access
PDF file
BJBattogtokh Jugdersuren
Battogtokh Jugdersuren
XLXiao Liu
Xiao Liu
JCJames C. Culbertson
James C. Culbertson
NMNadeemullah Mahadik
Nadeemullah Mahadik
OTOwain Thomas
Owain Thomas
YSYi Shu
Yi Shu
Silicene, a 2D hexagonal structure of silicon, has shown great promise for next-generation advanced electronic devices due to recent progress. However, one major obstacle to its application and integration into devices is its strong tendency of rapid oxidation in an ambient environment. Enhancing the chemical inertness by means of chemical modification without comprising its unique structure and properties is vital. Here, we report the fabrication of hydrogenated silicene grown on polycrystalline Ag films by means of plasma-enhanced chemical-vapor deposition (PECVD) with proper hydrogen dilution. Our Raman spectroscopy and x-ray diffraction results show the existence of typical monolayer and few-layer silicene. The x-ray photoelectron spectroscopy demonstrates its oxidation resistance after a few minutes of air exposure in a class 100 clean room. We propose that PECVD silicene can be an alternative to molecular-beam-epitaxy silicene for potential low-cost and large-area silicene applications.