1 September 2020 in Journal of Microelectromechanical Systems
The present work reports on the novel implementation of a miniaturized receiver for underwater networking merging a Piezoelectric Micromachined Ultrasonic Transducer (PMUT) array and signal conditioning circuitry in a single, packaged device. Tests in both a large water tank and a pool demonstrated that the system can attain large enough Signal-to-Noise Ratio (SNR) for communication at distances beyond two meters. An actual communication test, implementing an Orthogonal Frequency Division Multiplexing (OFDM) scheme, was used to characterize the performance of the link in terms of Bit Error Rate (BER) vs SNR. In comparison to previous work demonstrating high-data rate communication for intra-body links and acoustic duplexing, this implementation allows for significantly larger distances of transmission, while addressing the signal conditioning and submersible packaging needs for underwater conditions, thus enabling PMUT arrays for operating as complete underwater communication receivers. [2020-0185]
20 January 2022 in IEEE Transactions on Electron Devices
This article demonstrates, for the first time, a zero-power ultrasonic wakeup receiver for intra-body communication with Implantable Medical Devices (IMDs). The system is based on a 10 x 10 Piezoelectric Micromachined Ultrasonic Transducer (pMUT) array, a zero-power 500 nm gap MEMS plasmonic switch, a low-leakage CMOS load-switch, and an ad hoc sensing circuit. An ultrasonic signal of 10 mVpp is received by the pMUT array at a distance of 5 cm and brings the MEMS switch from the off-state (1 pA) to the on-state (20 μ A) when biased at 9.09 $V_{DC}$ . This small current then wakes up the load-switch (<10 nW when off), which powers up the sensing circuit to decode the pMUT signal. The system is demonstrated in a tissue phantom, making it ideal for intrabody communication.
21 November 2022 in IEEE Open Journal of Ultrasonics, Ferroelectrics, and Frequency Control
The present work reports on the novel usage of Scandium-doped Aluminum Nitride (AlScN) PMUT arrays for enhanced power transfer in implantable applications. Optimization considerations were explored for the PMUT array towards high performance. The transmission metric, compared to identical arrays based on Aluminum Nitride (AlN), showed a 25dB increase. Power transfer measurements also confirmed a considerable increase as compared to previous work based on AlN. Different matching strategies were explored to maximize the output power including inductor conjugate matching and matching utilizing resonators in series and parallel topologies. A full characterization of the transferred power versus incident acoustic intensity on the array revealed transmission of power levels of several milliwatts for intensities below the Food and Drug Administration’s (FDA) limit. The performance of the array, as compared with other implementations with a range of frequencies, dimensions and input acoustic intensities was bench-marked through the use of the conversion efficiency as the figure-of-merit. The practical applicability of the system, utilizing a realistic tissue phantom as the medium, was proven by interfacing with a commercially available boost converter to obtain a rectified voltage and power levels sufficient for powering and charging intra-body electronics.