This paper reports the relationship between oxygen concentration and dislocation multiplication in silicon crystals during directional solidification using numerical analysis. Based on the Alexander–Haasen–Sumino model, this analysis involved oxygen diffusion from the bulk to dislocation cores during crystal growth and annealing processes in a furnace. The results showed that the dislocation density mainly increased during cooling process, rather than crystal growth, when the effect of oxygen diffusion to dislocation cores was ignored. On the contrary, the dislocation density increased during both crystal growth and cooling processes when the effect of interstitial oxygen diffusion was considered. At a dislocation density larger than 1.0 × 105 cm−2, the interstitial oxygen concentration in bulk decreased due to the diffusion process, if interstitial oxygen atoms were between dislocations, whereas the concentration at dislocation cores increases.
1 February 2012 in Japanese Journal of Applied Physics
A numerical simulation has been carried out to study the asymmetric heat transfer, fluid flow, and three-phase line to explain the phenomenon of the spillage of the melt in floating zone (FZ) silicon growth. A three-dimensional high-frequency electromagnetic (EM) field is coupled with the heat transfer in the melt and crystal calculation domains. The current density along the three-phase line is investigated to demonstrate the inhomogeneous heating along the three-phase line. The asymmetric heating is found to affect the flow pattern and temperature distribution of the melt. The three-dimensional solid–liquid interface results show that, below the current supplies, the interface is deflected due to strong heating below the current supplies. The calculated asymmetric three-phase line shows a similar trend as the experimentally observed results. The results indicate that the re-melting and spillage phenomenon could occur below the current supplies.