Power generation units based on the bio-syngas system face two main challenges due to (i) the possible temporary shortage of primary sources and (ii) the engine power derating associated with the use of low-energy density fuels in combustion engines. In both cases, an external input fuel is provided. Hence, complementing syngas with traditional fuels, like natural gas, becomes a necessity. In this work, an experimental methodology is proposed, aiming at the quantification of the impact of the use of both natural gas and syngas in spark ignition (SI) engines on performance and emissions. The main research questions focus on investigating brake thermal efficiency (BTE), power derating, and pollutant emission (NO_x, CO, THC, CO₂) formation, offering quantitative findings that present the basis for engine optimization procedures. Experimental measurements were performed on a Toyota 4Y-E engine (a 4-cylinders, 4-stroke spark ignition engine) at partial load (10 kW) under different syngas energy shares (SES) and at four different spark ignition timings (10°, 25°, 35° and 45° BTDC). Results reveal that the impact of the different fuel mixtures on BTE is negligible if compared to the influence of spark advance variation on BTE. On the other hand, power derating has proven to be a limiting factor and becomes more prominent with increasing SES. An increasing SES also resulted in an increase of CO and CO₂ emissions, while NO_x and THC emissions decreased with increasing SES.

The (partial or total) substitution of petro-diesel with biodiesel in internal combustion engines (ICEs) could represent a crucial path towards the decarbonization of the energy sector. However, critical aspects are related to the controversial issue of the possible increase in Nitrogen Oxides (NO_x) emissions. In such a framework, the proposed study aims at investigating the effects of biodiesel share and injection timing on the performance and NO_x emissions of a diesel micro combined heat and power (CHP) system. An experimental campaign has been conducted considering the following operating conditions: (i) a reference standard injection timing (17.2° BTDC), an early injection timing (20.8° BTDC), and a late injection timing (12.2° BTDC); (ii) low (0.90 kW), partial (2.45 kW), and full (3.90 kW) output power load; and (iii) four fuel blends with different biodiesel (B) shares (B0, B15, B30, and B100). Experimental data were also elaborated on thanks to the response surface modelling (RSM) technique, aiming at (i) quantifying the influences of the above-listed variables and their trends on the responses, and (ii) obtaining a set of predictive numerical models that represent the basis for model-based design and optimization procedures. The results show: (i) an overall improvement of the engine performance due to the biodiesel presence in the fuel blend —in particular, B30 and B100 blends have shown peak values in both electrical (29%) and thermal efficiency (42%); (ii) the effective benefits of late SOI strategies on NO_x emissions, quantified in an overall average NO_x reduction of 27% for the early-to-late injection, and of 16% for the standard-to-late injection strategy. Moreover, it has emerged that the NO_x-reduction capabilities of the late injection strategy decrease with higher biodiesel substitution rates; through the discussion of high-prediction-capable, parametric, data-driven models, an extensive RSM analysis has shown how the biodiesel share promotes an increase of NO_x whenever it overcomes a calculated threshold that is proportional to the engine load (from about 66.5% to 85.7% of the biodiesel share).