In $_{\text{2}}$ O $_{\text{3}}$ has been recognized as a wide-gap transparent semiconductor oxide with high mobility, in which the oxygen plays an important role in its electronic properties. Here, we investigate the effects of air, O $_{\text{3}}$ and N $_{\text{2}}$ annealing on the electrical characteristics of a-In $_{\text{2}}$ O $_{\text{3}}$ thin film transistors (TFTs) by analyzing the behavior of weakly bonded oxygen (O $_{\text{wb}}$ ), excess oxygen (O $_{\text{ex}}$ ), and oxygen vacancy (V $_{\text{O}}$ ) in the channel layer. X-ray diffraction (XRD) result indicates an amorphous phase of In $_{\text{2}}$ O $_{\text{3}}$ layer after annealing. The oxygen behavior and bonding information before and after annealing of the In $_{\text{2}}$ O $_{\text{3}}$ films are investigated via X-ray photoelectron spectroscopy (XPS) measurements. The a-In $_{\text{2}}$ O $_{\text{3}}$ TFTs with field-effect mobility of 50–60 cm $^{\text{2}}$ /Vs and enhanced reliability are achieved by optimizing channel thickness and annealing conditions in air. The large threshold voltage shifting, reduced mobility, and low ON/OFF ratio of O $_{\text{3}}$ -annealed In $_{\text{2}}$ O $_{\text{3}}$ TFT are attributed to the existence of O $_{\text{ex}}$ . The hump-effect observed in N $_{\text{2}}$ -annealed In $_{\text{2}}$ O $_{\text{3}}$ TFT is attributed to the creation of a parasitic channel with high V $_{\text{O}}$ level above the main channel. The results reveal that O $_{\text{wb}}$ can be removed by thermal treatment, and V $_{\text{O}}$ can be partially filled and stabilized without introducing O $_{\text{ex}}$ by annealing the as-deposited In $_{\text{2}}$ O $_{\text{3}}$ TFTs in air at appropriate condition.
Oxygen post annealing is a promising method for improving the quality of the SiC metal oxide semiconductor (MOS) interface without the introduction of foreign atoms. In addition, a low oxygen partial pressure annealing atmosphere would prevent the additional oxidation of SiC, inhibiting the generation of new defects. This work focuses on the effect and mechanism of low oxygen partial pressure annealing at different temperatures (900–1250 °C) in the SiO2/SiC stack. N2 was used as a protective gas to achieve the low oxygen partial pressure annealing atmosphere. X-ray photoelectron spectroscopy (XPS) characterization was carried out to confirm that there are no N atoms at or near the interface. Based on the reduction in interface trap density (Dit) and border trap density (Nbt), low oxygen partial pressure annealing is proven to be an effective method in improving the interface quality. Vacuum annealing results and time of flight secondary ion mass spectrometry (ToF-SIMS) results reveal that the oxygen vacancy (V[O]) filling near the interface is the dominant annealing mechanism. The V[O] near the interface is filled more by O2 in the annealing atmosphere with the increase in temperature.
1 November 2025 in IEEE Transactions on Electron Devices
In this study, we propose a novel approach for modulating the threshold voltage (Vth) and subthreshold swing (SS) of indium gallium zinc oxide (IGZO) thin-film transistors (TFTs). The method relies on enhancing the Schottky barrier height (SBH) at the source/drain (S/D) contacts, which induces a positive shift in Vth and improves the SS by promoting carrier accumulation. Different from the conventional mechanism governed by channel electrons accumulation, the conduction in these IGZO TFTs is determined by the source–channel Schottky barrier. To validate this method, we fabricated IGZO Schottky barrier TFTs (SBTFTs) using platinum (Pt) as the S/D contacts material. Owing to its high work function, Pt forms an elevated SBH with the IGZO channel. Replacing conventional indium tin oxide (ITO) contacts with Pt resulted in a reduction in SS from 119 mV/dec to 87 mV/dec and a positive Vth shift from -0.10 V to +1.40 V. Furthermore, the bias stability was significantly improved, as evidenced by a reduced positive bias temperature instability (PBTI) shift from +0.52 V to +0.10 V under 2 MV/cm for 3600 s at 25 oC. This demonstration confirms that engineering the Schottky barrier can effectively enhance the transfer characteristics and bias stability of IGZO TFTs.
30 October 2025 in IEEE Transactions on Electron Devices
Precise characterization of the subgap defects in the study of In2O3-based oxide semiconductors is of crucial importance for improving the device performance and reliability to meet the needs for future high-density high-bandwidth dynamic random access memory (DRAM) applications. However, the contradiction between high detection accuracy and miniaturized film thickness becomes an obstacle for the current methods. In this study, we propose a new variable photocurrent method (VPM) for subgap characterization, which has been successfully utilized in In2O3-based devices. Compared with the conventional constant photocurrent method (CPM), maintaining a constant current is unnecessary for our proposed VPM, making it more convenient and applicable. Comparative studies on the annealing-induced absorption coefficient obtained by VPM in In2O3 and InGaO (IGO) TFTs with a thin channel (~15 nm) observe two close subgap defect levels, which are consistent with the electrical and material characterization, verifying the feasibility and potential of VPM in thin-film oxide semiconductors.