Magnetized plasma studies are necessary for many applied studies, including laser-driven inertial fusion, modeling astrophysically relevant phenomena, and innovative industrial and medical applications. An interesting method of generating highly magnetized plasma can be based on the interaction of a laser with spiral-shaped cavity (snail-like) targets. A target shaped in this way can represent the central area of a spherical pellet that is not irradiated radially, but rather through an entrance hole allowing the laser beam to almost impact its inner surface tangentially (Pisarczyk et al 2018 Sci. Rep.8 17 895). In the reported experiment, snail targets of various diameters were irradiated by linearly or circularly polarized radiation of a Prague asterix laser system (PALS) iodine laser delivering ∼500 J, 350 ps and 1.315 μm pulses on targets. Three-frame complex interferometry demonstrated that plasma is generated on the entire inside and outside surfaces of the snail target, starting from the very beginning of the laser–target interaction. The time-resolved records of the magnetic field and the electron density distribution inside and outside the snail target characterize the changes in the structure of the magnetized plasma. Inside the target, the magnetic field survives long after the termination of the laser–matter interaction, namely longer than 10 ns. Compared to a circularly polarized laser pulse, the irradiation of targets with a p-polarized beam increases both the emission of hot electrons (HEs) and the intensity of the magnetic field. The emission of HEs is not isotropic, and their energy distribution cannot be characterized by a single temperature.
27 September 2024 in Plasma Physics and Controlled Fusion
Experimental and theoretical study of plasma processes affected by strong laser generated magnetic fields is reported. The PALS laser system operating at 3 ω (438.5 nm) delivered intensities up to 1 × 1016 W cm−2 on targets. By using a special target system consisting of a Cu foil connected to a sub-mm coil, magnetic fields up to the level of 10 T were generated. This is 1.4 times higher than the field generated with a 1.315 mm (1 ω) laser beam at a comparable intensity. We found that these fields were sufficiently strong to modify plasma blow-off from the foil which resulted in the changed expansion dynamics and increased energy of hot electrons (HE) by 20%–40% compared to the plasma unaffected by the magnetic field. To obtain complementary experimental data, a complex diagnostic system was used enabling the visualization of the plasma expansion process both in visible light (3-frame composite interferometry) and in the soft x-ray region (4-frame pinhole x-ray camera) together with measurements of the HE parameters using two-dimensional imaging of the Kα line emission from the Cu target and electron spectroscopy. Experimental data obtained from the angular distribution of electron energy spectra were used for three-dimensional (3D3V) numerical PIC simulations using a modified EPOCH code. By including interactions between ions, protons, hot and thermal electrons in forward and backward propagating particles, the effects of the magnetic field on the flux of HE were visualized and compared with the experiment. The PIC simulation confirmed that the interaction of the HE flux with the magnetic field generated by the target-coil system leads to an increased flux energy. However, this increase is accompanied by increased complexity of the spatial structure and heterogeneity of the flux as well as its angular divergence.
We experimentally demonstrate the generation of quasi-monoenergetic electron bunch at the end of the electron energy distribution. The experiment was conducted at the Prague Asterix Laser System where iodine laser supplies laser energy up to 600 J at the fundamental wavelength of 1.315 μm with a pulse duration of 350 ps. The thickness of different target materials (Cu, Sn, Ta, Pb) was varied between 10 and 25 μm. The energy spectrum of electrons was measured using an array of electron spectrometers at different angular directions with respect to the laser axis. Three frame femtosecond interferometry driven by a Ti:Sa laser was implemented to scan the changes in electron density during plasma ignition by the iodine laser. The experimental results indicate the generation of well-defined quasi-monoenergetic peaks in the electron energy distribution. The energy range of the measured quasi-monoenergetic peaks lies between 0.6 and 1.5 MeV; however, the energy spread of the distribution varies between 4% and 12%. These features were observed consistently in the electron spectrum and illustrate the quasi-monoenergetic electron beam generation by interaction of a sub-nanosecond laser beam with plasma. In addition, a comparison of electron spectra from spectrometers located in opposite directions relative to the position of the laser focus indicates the splitting of the electron cloud into plasma blocks during the acceleration of hot electrons by Coulomb repulsion. These findings can be applicable in fast electron beam-driven radiation sources, electromagnetic pulse generation, charge particle acceleration, and inertial fusion studies.
In this Letter, we report the possibility of generating intense, highly energetic proton beams using terawatt, sub-nanosecond class laser system by irradiating modified cavity pressure acceleration-type targets. In this approach, the main source of few-mega electron volt protons is thermonuclear deuterium–deuterium reaction; therefore, the energy spectrum of accelerated particles and their number is not as strongly related to the laser intensity (laser pulse energy and pulse duration in particular) as in the case of the most common ion acceleration mechanism, namely, target normal sheath acceleration. Performed Monte Carlo simulations suggest that using mentioned mechanism to generate proton beam might be beneficial and efficient driver for laser induced proton–boron fusion when moderate-to-low laser pulse intensities ( ⩽ 1016W/cm2) and thin, lower than 100 μm boron foils are used as catchers.
Recent experiments at the National Ignition Facility and theoretical modeling suggest that side stimulated Raman scattering (SSRS) instability could reduce laser–plasma coupling and generate considerable fluxes of suprathermal hot electrons under interaction conditions envisaged for direct-drive schemes for inertial confinement fusion. Nonetheless, SSRS remains to date one of the least understood parametric instabilities. Here, we report the first angularly and spectrally resolved measurements of scattered light at laser intensities relevant for the shock ignition scheme (I ∼ 1016 W/cm2), showing significant SSRS growth in the direction perpendicular to the laser polarization. Modification of the focal spot shape and orientation, obtained by using two different random phase plates, and of the density gradient of the plasma, by utilizing exploding foil targets of different thicknesses, clearly reveals a different dependence of backward SRS (BSRS) and SSRS on experimental parameters. While convective BSRS scales with plasma density scale length, as expected by linear theory, the growth of SSRS depends on the spot extension in the direction perpendicular to laser polarization. Our analysis therefore demonstrates that under current experimental conditions, with density scale lengths Ln ≈ 60–120 μm and spot sizes FWHM ≈ 40–100 μm, SSRS is limited by laser beam size rather than by the density scale length of the plasma.
This article provides an up-to-date overview of the problems associated with the detection of hot electrons escaping from laser-produced plasma and corresponding return current flowing from the ground to the target, which neutralises the positive charge occurring on the target due to the escaped electrons. In addition, the target holder system acts as an antenna emitting an electromagnetic pulse (EMP), which is powered by the return target. If the amount of positive charge generated on the target is equal to the amount of charge carried away from the plasma by the escaping electrons, the measurement of the return current makes it possible to determine this charge, and thus also the number of escaped electrons. Methods of return current detection in the mA–10 kA range is presented, and the corresponding charge is compared to the charge determined using calibrated magnetic electron energy analysers. The influence of grounded and insulated targets on the number of escaped electrons and EMP intensity is discussed. In addition to EMP detection, mapping of the electrical potential near the target is mentioned.