Deepthi Cingu

Deepthi Cingu

Auto-generated profile, based on publicly available information

Deepthi Cingu

IMEC, Leuven, Belgium

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 February 2024 in IEEE Electron Device Letters
Verified
Journal Article
Closed access
SKS. Kumar
S. Kumar
KGKaren Geens
Karen Geens
AVA. Vohra
A. Vohra
DWD. Wellekens
D. Wellekens
DCD. Cingu
D. Cingu
SDStefaan Christiaan Decoutere
Stefaan Christiaan Decoutere
This letter experimentally demonstrates 1.2 kV normally-off p-GaN gate lateral high-electron-mobility transistors (HEMTs) on 200 mm diameter engineered substrates. The fabricated p-GaN gate HEMT with optimum gate-drain spacing exhibits a threshold voltage (V th ) of 3.2 V, an ON/OFF ratio of 10 8 , low specific ON-resistance (R on,sp ) of 5.8 mΩ-cm 2 and hard breakdown voltage (V bd ) at 1800 V. Optimized devices also show good wafer scale uniformity (σ Ron = 1.2%) for the evaluated electrical parameters and passed on-wafer high temperature gate bias (HTGB) and reverse bias stress tests without device failures.

12 January 2021 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
DCDeepthi Cingu
Deepthi Cingu
Xiangdong LiXiangdong Li
Xiangdong Li
Benoit BakerootBenoit Bakeroot
Benoit Bakeroot
NANooshin Amirifar
Nooshin Amirifar
KGKaren Geens
Karen Geens
SDStefaan Christiaan Decoutere
Stefaan Christiaan Decoutere
Synchronous buck converter comprises a low side (LS) and a high side (HS) switch, where the HS switch works in the first quadrant (forward conduction) whereas the LS switch works in the third quadrant (reverse conduction). However, the reliability of the p-GaN gate high electron mobility transistor (HEMT) in reverse conduction is unclear. In this work, a comprehensive evaluation of this conduction mode for 200-V HEMTs was conducted. First, devices were subjected to time-dependent breakdown (TDB) measurements. By comparing different device configurations, the time to failure (TTF) was found to only scale with the number of gate fingers instead of the gate width ${W}_{G}$ , proving the critical spots are the intersection of gate fingers over the N implantation isolation. The reverse operation voltage of ${V}_{DS}$ for ten years lifetime was extrapolated to be −5.4 V, corresponding to a failure of 0.01% and 100 gate fingers. Second, the devices were submitted to 200-V ${V}_{DS}$ OFF-state stress for 10 s, after which the reverse drain current saw a negligible degradation. Third, the reverse conduction of the HEMTs only showed a very limited deterioration after a long-time bias temperature instability (BTI) stress at ${V}_{DS} = - 5.5$ V and ${V}_{GS} = 0$ V. This work proves the p-GaN gate HEMTs bear a high reliability in reverse conduction, which can simplify the design of synchronous power system.

29 December 2023 in IEEE Transactions on Electron Devices
Verified
Journal Article
Open access
KGKaren Geens
Karen Geens
MBMatteo Borga
Matteo Borga
MKM. A. Khan
M. A. Khan
WFW. Gonçalez Filho
W. Gonçalez Filho
AVA. Vohra
A. Vohra
SDStefaan Christiaan Decoutere
Stefaan Christiaan Decoutere
To make vertical GaN-based trench gate MOSFET devices commercially manufacturable, 200 mm engineered substrates with a poly-AlN core are a good substrate choice. The poly-AlN core, matched in thermal expansion to GaN, allows to grow high-quality thick GaN layers. Up to 11 $\mu$ m-thick GaN stacks were grown crack-free, with excellent control over the wafer warp. Breakdown values of 900 V were reached for the vertical p/n-junction. Full device processing was completed in a CMOS-compatible pilot line without any wafer breakage, demonstrating the mechanical strength of these substrates. On module level, a new gate trench profile combining a smooth sidewall and round corners, is presented. While a smooth sidewall is important for the ON-state performance of the devices, the rounded corners are beneficial for the OFF-state operation. A semi-vertical test vehicle was used to demonstrate the ON-state of the fabricated power transistors. For devices with an effective gate width ( $\textit{W}_{\text{G,\text{ef}\text{f}}}\text{)}$ of 180 mm and an active area of 1.4 mm $^{\text{2}}$ , an ON-state resistance could be achieved of 8 m $\Omega\cdot \text{cm}^{\text{2}}$ . By scaling the source contact length down, the device footprint could be decreased further. It is shown that for devices with a $\textit{W}_{\text{G,\text{ef}\text{f}}}$ of 60 mm this value could be further improved with best performing devices showing a 6.2 m $\Omega\cdot\text{ cm}^{\text{2}}$ ON-state resistance.

11 March 2024 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
WFWalter Gonçalez Filho
Walter Gonçalez Filho
MBMatteo Borga
Matteo Borga
KGKaren Geens
Karen Geens
AKArif Khan
Arif Khan
DCDeepthi Cingu
Deepthi Cingu
Benoit BakerootBenoit Bakeroot
Benoit Bakeroot
This work addresses the impact of the Mg activation anneal step and the resulting acceptor concentration on the channel mobility and VT stability of vertical MOSFETs. Increasing the annealing time with N2 only ambient and the annealing temperature with O2 in the ambient is shown to be effective in increasing the channel acceptor concentration. When the effective acceptor concentration is increased, the mobility is degraded due to a transition in the main scattering mechanism from Coulomb to surface roughness scattering. Degradation of the on-state current and maximum transconductance at high operating temperatures was linked to bulk mobility degradation of the drift layer due to lattice scattering. The two Mg activation annealing conditions considered here show different trends with regard to the threshold voltage stability, while N2 only ambient did not impact this parameter, including O2 increased threshold voltage instability. It is shown that increasing the Mg chemical concentration in the p-GaN layer degrades channel mobility and threshold voltage stability, irrespectively of the effective acceptor concentration, providing evidence for degradation of the channel/dielectric interface characteristics with higher Mg chemical concentration. This study shows that it is possible to achieve very low threshold voltage hysteresis and high channel mobility by reducing the Mg chemical concentration while maintaining high effective acceptor concentration. These results provide key insights for the development of vertical GaN FETs.

22 July 2024 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
WFWalter Gonçalez Filho
Walter Gonçalez Filho
MBMatteo Borga
Matteo Borga
KGKaren Geens
Karen Geens
AKArif Khan
Arif Khan
DCDeepthi Cingu
Deepthi Cingu
Benoit BakerootBenoit Bakeroot
Benoit Bakeroot
This article discusses the electrical stability of MOS structures on n- and p-type GaN for two different dielectrics, AlON and Al2O3, deposited by atomic layer deposition (ALD). Threshold voltage hysteresis was evaluated by means of capacitance–voltage (C–V) double sweep measurements, performed on MOS capacitors. MOS structures on p-doped GaN show up to two orders of magnitude higher effective trapped charge density than on n-GaN. Moreover, AlON results in 10 times less trapped charge than Al2O3 on p-GaN. The leakage current is also identified as an important factor in defining the electrical stability at high electric fields, due to the enhanced injection of electrons into the MOS stack. Electron trapping is shown to happen either at the dielectric–semiconductor interface or in border traps. AlON results in lower flat-band and threshold voltages likely due to the resulting fixed interface charge from surface reconstruction. The effect of the n-type doping density as well as of dry etch damage on the effective trapped charge after injection has been shown to be minimal. These results are important for different insulated gate device architectures. We show that extremely low threshold voltage hysteresis values can be reached in a trench-shaped gate GaN MOSFET using AlON as an interface dielectric.

9 January 2026 in Journal of Applied Physics
Verified
Journal Article
Open access
WFWalter Gonçalez Filho
Walter Gonçalez Filho
MBMatteo Borga
Matteo Borga
KGKaren Geens
Karen Geens
AKArif Khan
Arif Khan
DCDeepthi Cingu
Deepthi Cingu
Benoit BakerootBenoit Bakeroot
Benoit Bakeroot
The leakage conduction mechanisms in AlON dielectric deposited on GaN are identified and compared to the findings for Al2O3. Poole–Frenkel emission from similar trap energy levels was identified in both atomic layer deposited AlON and Al2O3¸ despite at different electric field ranges, while Fowler–Nordheim tunneling dominated the leakage current characteristics for Al2O3 at average electric field values. It is concluded that the differences observed in the leakage characteristics for these dielectrics are likely a result of the slightly larger conduction band offset between AlON and GaN. The identification of the same trap state energy level responsible for Poole–Frenkel emission in AlON and Al2O3 means that this trap state does not originate from the presence of nitrogen in the dielectric and is related to AlOx compounds and the deposition method. Bulk charge trapping is shown to play a major role in the leakage characteristics of AlON from average to high electric fields, which shifts the transfer characteristics from a certain electric field onward and causes hysteresis. These results provide valuable insights into the development of insulated gate architectures on GaN using the promising dielectric material AlON as the gate oxide.