Milad Kalantari

Milad Kalantari

Auto-generated profile, based on publicly available information

Milad Kalantari

Department of Electronic and Computer Engineering, The Hong Kong University of Science and Technology, Hong Kong

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 November 2020 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
MKMilad Kalantari
Milad Kalantari
WLWang Li
Wang Li
HSHossein Shirinabadi
Hossein Shirinabadi
AFAli Fotowat-Ahmady
Ali Fotowat-Ahmady
Chik Patrick YueChik Patrick Yue
Chik Patrick Yue
This article presents a leakage cancellation architecture for single-antenna frequency-modulated continuous-wave (FMCW) radars at W-band. A shared antenna for transmitter (TX) and receiver (RX) can substantially reduce the form factor, cost, and complexity of radar modules. Due to the simultaneous operation of the TX and RX in FMCW radars, employing a shared antenna will, however, significantly increase TX-to-RX leakage, resulting in RX saturation and desensitization. Our proposed cancellation scheme employs analog feedback to confine the TX leakage right at the RX input port, and thus, relieves the ongoing RX chain from saturation. The proposed single-antenna transceiver (TRX) prototype was fabricated in 65-nm CMOS technology with a die area of 1 mm². The output power of 2 dBm was achieved for the TX in a frequency range of 80-84 GHz. In addition, a conversion gain and noise figure of 45 and 15 dB was measured for the RX in the presence of the TX signal via a shared antenna port. TX-to-RX isolation of more than 45 dB was achieved in the operating W-band. The chip consumes 108 mW (80.5 mW for the TX and 27.5 mW for the RX) from a 1.2-V supply voltage. Moreover, the functionality of the single-antenna radar operation was verified by connecting the chip to an on-printed circuit board (PCB) 4x8 patch antenna array with a simulated gain of 15 dBi, implemented on RO3003 Rogers material. Using the single-antenna radar module as a demo system, a 40x50 cm² rectangular metallic plate was detected at a distance up to 19 m.

12 February 2020 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
XMXiangyu Meng
Xiangyu Meng
MKMilad Kalantari
Milad Kalantari
BCBaoyong Chi
Baoyong Chi
WCWenhua Chen
Wenhua Chen
Zhijian ChenZhijian Chen
Zhijian Chen
Chik Patrick YueChik Patrick Yue
Chik Patrick Yue
This work presents the design and implementation of an ultra-broadband quadrature common-mode amplitude modulator (QCAM) to generate high power back-off efficiency 16-QAM signals. The proposed QCAM transmitter consists of I- and Q-path PAM4 modulators, which digitally modulate the power amplifier (PA) output stage to relax the linearity requirement. An interleaved differential transformer-based coupler is proposed for wide-band combination of the baseband and LO signals. The I and Q PAM4 signals are combined using an on-chip Wilkinson power combiner to generate the 16-QAM output signal. The 28-GHz 16-QAM transmitter test chip, implemented in 65-nm CMOS, achieved measurement results of 11.35 dBm average RF output power, 9.2% DC-RF efficiency, 16 Gb/s data rate, and -24 dB EVM.

8 January 2021 in IEEE Open Journal of Circuits and Systems
Verified
Journal Article
Open access
CWCan Wang
Can Wang
LWLi Wang
Li Wang
ZZZhao Zhang
Zhao Zhang
MMMilad Kalantari Mahmoudabadi
Milad Kalantari Mahmoudabadi
WSWeimin Shi
Weimin Shi
Chik Patrick YueChik Patrick Yue
Chik Patrick Yue
This article presents a quarter-rate source-synchronous PAM-4 receiver for energy-efficient chip-to-module communication. A novel single-stage multiple peaking continuous-time linear equalizer (MP-CTLE) using feedback enabled multiple peaking scheme for both high-frequency equalization (HF-EQ) and low-frequency equalization (LF-EQ) is proposed to improve the BER performance and overall energy efficiency. The LF-EQ of the MP-CTLE eliminates the need for many DFE taps in SR/VSR applications to save power and area. A 1-tap feedforward equalizer (FFE) is used to further compensate for the high-frequency loss. We also use a ring oscillator based wide bandwidth phase-locked loop (WBW-PLL) as the multiphase clock generator (MPCG) in the clock and data recovery loop to save power with acceptable phase accuracy. Fabricated in 40-nm CMOS technology, the prototype receiver chip achieves error-free operation up to 52 Gb/s PAM-4 with superior bit efficiency of 0.126pJ/bit/s/dB while compensating 7.3-dB channel loss at 13GHz. With the proposed single-stage MP-CTLE, the receiver extends the error-free operation from PRBS-7 to PRBS-9. The BER bathtub curve at $10^{-6}$ is improved from 0.018 UI to around 0.1 UI.