Hongjian Li

Dr. Hongjian Li

Materials Department, University of California, Santa Barbara, CA 93106-5055, USA

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 August 2021 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
Panpan LiPanpan Li
Panpan Li
Hongjian LiHongjian Li
Hongjian Li
HZHaojun Zhang
Haojun Zhang
CLCheyenne Lynsky
Cheyenne Lynsky
MIMike Iza
Mike Iza
Steve DenBaarsSteve DenBaars
Steve DenBaars
Red micro-light-emitting diodes (μLEDs) have been generated significant interest for the next generation μLEDs displays. It has been shown that the external quantum efficiency (EQE) of AlInGaP red μLEDs markedly decreases as the size goes to very small dimension. Here, we demonstrate size-independent peak EQE of 611 nm InGaN red μLEDs. Packaged μLEDs show a peak EQE varied from 2.4% to 2.6% as the device area reduces from 100 × 100 to 20 × 20 μm2. These results demonstrate the promising potential for realizing high efficiency red μLED with very small size using InGaN materials.

12 May 2023 in ACS Photonics
Verified
Journal Article
Closed access
PLPanpan Li
Panpan Li
Hongjian LiHongjian Li
Hongjian Li
YYYifan Yao
Yifan Yao
NLNorleakvisoth Lim
Norleakvisoth Lim
MWMatthew Wong
Matthew Wong
SDSteven P. DenBaars
Steven P. DenBaars

21 March 2022 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
Panpan LiPanpan Li
Panpan Li
Hongjian LiHongjian Li
Hongjian Li
HZHaojun Zhang
Haojun Zhang
YYYunxuan Yang
Yunxuan Yang
MWMatthew S. Wong
Matthew S. Wong
Steve DenBaarsSteve DenBaars
Steve DenBaars
We present efficient red InGaN 60 × 60 μm2 micro-light-emitting diodes (μLEDs) with an epitaxial tunnel junction (TJ) contact. The TJ was grown by metal-organic chemical vapor deposition using selective area growth. The red TJ μLEDs show a uniform electroluminescence. At a low current density of 1 A/cm2, the emission peak wavelength is 623 nm with a full-width half maximum of 47 nm. The peak external quantum efficiency (EQE) measured in an integrating sphere is as high as 4.5%. These results suggest a significant progress in exploring high efficiency InGaN red μLEDs using TJ technology.

9 October 2017 in ACS Applied Materials & Interfaces
Verified
Journal Article
Closed access
Hongjian LiHongjian Li
Hongjian Li
MKMichel Khoury
Michel Khoury
BBBastien Bonef
Bastien Bonef
AAAbdullah I. Alhassan
Abdullah I. Alhassan
AMAsad Jahangir Mughal
Asad Jahangir Mughal
Steve DenBaarsSteve DenBaars
Steve DenBaars

6 December 2021 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
Panpan LiPanpan Li
Panpan Li
ADAurelien David
Aurelien David
Hongjian LiHongjian Li
Hongjian Li
HZHaojun Zhang
Haojun Zhang
CLCheyenne Lynsky
Cheyenne Lynsky
Steve DenBaarsSteve DenBaars
Steve DenBaars
We study the high-temperature electroluminescence properties of 600 nm InGaN red 40 × 40 μm2 micro-light-emitting diodes (μLEDs) with a peak external quantum efficiency (EQE) of 3.2%. Temperature-dependent peak wavelength measurements show a low redshift of 0.05 nm/K. The injection efficiency improves with increasing temperature. The hot/cold (HC) factor is used to quantify the thermal droop: at 400 K, the EQE and wall-plug efficiency HC factors at 50 A/cm2 reach high values of 0.72 and 0.85, respectively. This demonstrates the robustness of InGaN red μLEDs up to high temperature, with a much-improved stability over conventional AlInGaP red μLEDs.

8 November 2021 in Crystals
Verified
Journal Article
Open access
PDF file
RWRyan White
Ryan White
Hongjian LiHongjian Li
Hongjian Li
MKMichel Khoury
Michel Khoury
CLCheyenne Lynsky
Cheyenne Lynsky
MIMichael Iza
Michael Iza
Steve DenBaarsSteve DenBaars
Steve DenBaars
In this paper, we report the successful demonstration of bright InGaN-based microLED devices emitting in the red spectral regime grown by metal organic chemical vapor deposition (MOCVD) on c-plane semi-relaxed InGaN substrates on sapphire. Through application of an InGaN/GaN base layer scheme to ameliorate high defect density and maintain appropriate lattice constant throughout the growth, high-In quantum wells (QWs) can be grown with improved crystal quality. Improvement to the design of the growth scheme also yields higher power output resulting in an increase to the external quantum efficiency (EQE). Combined, these two improvements allow for an 80 × 80 μm2 microLED device emitting at 609 nm to achieve 0.83% EQE. Furthermore, the true In content of the QW is measured using atomic probe tomography (APT) to confirm the improved In incorporation during high temperature active region growth. These developments represent advancement toward the realization of bright, highly efficient red III-nitride LEDs to be used in RGB applications under one material system.