12 September 2011 in Applied Physics Letters
The efficiency of the ammonium sulfide vapor (ASV) treatment, as opposed to the wet treatment in the liquid ammonium sulfide solution, on the performance improvement of the In0.53Ga0.47As surface-channel as well as InP-capped buried-channel metal-oxide-semiconductor field-effect-transistors (MOSFET) was demonstrated for the first time. MOSFETs were fabricated with either HCl or ASV surface treatments prior to the gate oxide deposition. ASV treatment was found to be very efficient in boosting the drive current of the transistors compared to that of the HCl treatment. It was also found that the ASV treatment leads to a lower border trap density and slightly higher oxide/semiconductor interface defect density compared to that of the HCl treatment. X-ray photoelectron spectroscopy (XPS) studies of In0.53Ga0.47As native oxide regrowth after both surface treatments identified indium sub-oxides as a possible cause of the performance degradation of the HCl treated devices. Based on this work, ASV treatment could be an efficient solution to the passivation of III-V surfaces.
31 January 2024 in IEEE Microwave and Wireless Technology Letters
We demonstrate high linearity of fully processed GaN on 2-mm high resistivity (HR) Si wafers with high effective resistivity ( $\rho_{\mathbf{eff}}$ $>$ 2 k $\Omega $ $\cdot$ cm). Using two common-gate (MOS-)HEMT devices presenting different levels of distortion as demonstrators, we discuss the impact of substrate-induced harmonic distortion (HD) on RF switches. By comparing switch and CPW line measurements, it is possible to estimate the substrate contribution to HD. For the relatively nonlinear device, the intrinsic device nonlinearities dominate by a 16–20-dB margin over the substrate contribution. For a more linear device ( $-$ 110 dBc of second harmonic power at 900 MHz and P $_{\mathbf{in}}$ $=$ 15 dBm), the substrate distortion contributes equally to channel nonlinearity, highlighting the necessity of engineering the substrate’s RF performance together with the transistor. We provide guidelines for substrate $\rho_{\mathbf{eff}}$ to achieve good switch linearity for given device harmonic levels.
23 May 2022 in Applied Physics Letters
High-temperature processing steps are frequently used in manufacture of AlGaN/(AlN/)GaN high electron mobility transistors (HEMTs). The thermal budgets drive Al diffusion into the GaN channel, increase alloy disorder scattering (ADS) of the two-dimensional-electron-gas (2DEG), and degrade the 2DEG mobility. By correlating the ADS to device thermal budget, we propose an analytical model to calculate the ADS limited mobility as a function of Al diffusion lengths (LD,Al) in AlGaN/(AlN/)GaN HEMTs. The simulation indicates that the ADS is a significant mobility degradation mechanism whose scattering rate increases with the 2DEG density and the LD,Al. The findings explain the generally observed trends in the literature that the 2DEG mobility and sheet resistances of GaN heterostructures degrade with increased thermal budgets, especially after >900 °C processing.
1 August 2024 in IEEE Transactions on Microwave Theory and Techniques
Gate current is known to limit device performance, yet a detailed analysis of its impact on RF power performance has not been extensively documented. This article examines the influence of gate current on RF power performance. A small-signal equivalent-circuit analysis shows that gate current degrades the device’s RF power performance, with higher gate currents causing greater degradation. In addition, the effect of gate current varies with frequency due to the frequency-dependent impedance of $C_{\text{gs}}$ and $C_{\text{gd}}$ , resulting in more significant degradation at lower frequencies because of the parallel connection of gate conduction with these capacitors. These findings are validated under large-signal conditions using an experimentally verified device model for InAlN/GaN high-electron-mobility transistors (HEMTs).
2 June 2024 in Physica Status Solidi (a)
28 August 2025 in IEEE Transactions on Electron Devices
NBNelson de Almeida Braga
+12
This study comprehensively investigates the threshold voltage ( ${V}_{\text {th}}\text {)}$ instability of AlGaN/GaN MIS-HEMTs under semi-bioscon state conditions. The effects of various temperatures and drain biases are studied. Under semi-bioscon bias conditions, a significant negative ${V}_{\text {th}}$ shift up to −1.0 V is observed in MIS-HEMTs with 10-nm in-situ SiN gate dielectrics, whereas Schottky HEMTs exhibit a negligible ${V}_{\text {th}}$ shift. A gate current analysis, comparing the MIS-HEMT with the source grounded versus floating, suggests that hot electrons induce generation of holes under the semi-on state. TCAD simulations corroborate that the high electric field across the channel of the MIS-HEMT induce hot electrons and hole generation under the semi-bioscon state; dynamic interaction of hot electrons and holes with the gate SiN/AlGaN interfacial states leads to bias temperature instability (BTI) of the ${V}_{\text {th}}$ of the MIS-HEMT. These findings suggest that optimizing the gate dielectric and its interface with the top barrier is crucial to improve the semi-bioscon state stability of radio-frequency (RF) MIS-HEMTs.