Jonas L. S. Dickmanns

Jonas L. S. Dickmanns

Auto-generated profile, based on publicly available information

Jonas L. S. Dickmanns

Technical University of Munich, Germany; TUM School of Natural Sciences, Department of Chemistry and Catalysis Research Center, Chair of Technical Electrochemistry

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 October 2023 in Electrochimica Acta
Verified
Journal Article
Open access
SSSandro Stock
Sandro Stock
JHJan Hagemeister
Jan Hagemeister
SGSophie Grabmann
Sophie Grabmann
JKJohannes Kriegler
Johannes Kriegler
JKJosef Keilhofer
Josef Keilhofer
RDRüdiger Daub
Rüdiger Daub

21 August 2024 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
PDF file
SFSven Friedrich
Sven Friedrich
SHSimon Helmer
Simon Helmer
LRLennart Reuter
Lennart Reuter
JDJonas L. S. Dickmanns
Jonas L. S. Dickmanns
ADAxel Durdel
Axel Durdel
Andreas JossenAndreas Jossen
Andreas Jossen
Microscale silicon particles have a higher specific capacity but larger volume expansion than graphite particles, leading to particle decoupling and lifetime limitations. This study investigates a wide range of external mechanical pressures from zero (ZP - 0.00 MPa) to high (HP - 0.50 MPa) pressure to determine the optimal pressure for high rate capability, cyclic lifetime, energy density, low temperature rise, and low cell thickness gain. The cells are characterized by rate tests and impedance spectroscopy, and are aged until 70% state of health (SoH). The post-mortem analysis after 70% SoH and thickness measurements over 360 cycles in a compression test bench offer insights into the thickness gain. Electrochemical results reveal an immediate reduction in discharge capacity upon transitioning from normal pressure (NP - 0.20 MPa) to ZP, with NP and HP exhibiting superior performance over aging. The impedance was reduced initially and over aging for higher mechanical pressures, especially the cathode contact resistance, resulting in lower temperature rises during the rate tests. Overall, applying higher pressures reduced the anode and cell thickness gain. Moreover, the porosity decreased with increasing pressure, as determined by mercury intrusion porosimetry and pycnometer measurements. The increase of the anode mass correlates to the total charge throughput, which is pressure-dependent and the highest for NP.

1 July 2025 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
JDJonas L. S. Dickmanns
Jonas L. S. Dickmanns
LRLennart Reuter
Lennart Reuter
RMRobert Morasch
Robert Morasch
FMFilippo Maglia
Filippo Maglia
RJRoland Jung
Roland Jung
HGHubert A. Gasteiger
Hubert A. Gasteiger
With the interest in achieving higher gravimetric and volumetric energy densities in lithium-ion batteries, increasing the electrode loading and reducing its thickness—and consequently porosity—while maintaining low tortuosity is desirable. Achieving high power density requires a thorough understanding of these structural parameters of thick graphite electrodes and their changes during the formation of the solid-electrolyte-interphase (SEI). Graphite electrodes with loadings of ∼ 10 mg cm − 2 and pristine porosities ranging from 20–50% underwent formation at 45 °C in LP57 + 2% VC electrolyte. The ionic pore resistance after formation was quantified in non-blocking conditions using a μ-reference electrode and measuring electrochemical impedance spectroscopy at −5 °C. Upon formation, the ionic resistance of the graphite electrodes increased by up to 25%, which was quantitatively related to specific changes in electrode thickness, porosity, and tortuosity. The change in electrode thickness depended on the pristine porosity and increased by up to ∼11%. Mercury intrusion porosimetry revealed a decrease in porosity for initially high-porosity electrodes and an increase for those with low pristine porosity. The tortuosity of the electrodes increased by up to ∼10% upon formation. The thickness and density of the SEI were determined using a combination of pycnometry and mass-gain measurements, yielding 16–20 nm and ∼ 1.07 g cm − 3 , respectively.

1 May 2024 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
LRLennart Reuter
Lennart Reuter
JDJonas L. S. Dickmanns
Jonas L. S. Dickmanns
BSBenjamin Strehle
Benjamin Strehle
LHLouis Hartmann
Louis Hartmann
FMFilippo Maglia
Filippo Maglia
HGHubert A. Gasteiger
Hubert A. Gasteiger
The evolution of gases is often associated with the decomposition of the electrolyte or active materials. Thus, its detection can be powerful for understanding degradation mechanisms in Li-ion batteries (LIBs). Here, we present an evaluation method for gas detection and quantification by on-line electrochemical mass spectrometry (OEMS) when using volatile electrolytes (e.g., electrolytes with linear alkyl carbonates) and a new OEMS cell design for improved leak tightness. With a significant fraction of the gases in the cell head-space being electrolyte vapor, we observe a pressure/time-dependency of the electrolyte background in the mass spectrometer, for which we here developed a correction method. We apply this method for the temperature-dependent gas analysis of a graphite/NCM831205 full-cell with an LP57 (1 M LiPF6 in EC:EMC 3:7 wt:wt) electrolyte. We conclude that the activation energy of the gas evolution associated with the formation of the solid-electrolyte interphase (SEI) is ∼15–20 kJ mol−1. Furthermore, we identify a significant temperature dependence of the lithium alkoxide triggered trans-esterification of EMC with an activation energy of ∼70 kJ mol−1. Lastly, the temperature-dependent analysis reveals the relation between the evolution of hydrogen related to water and HF impurities during the initial SEI formation and in situ generated protons.

23 January 2026 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
JDJonas L. S. Dickmanns
Jonas L. S. Dickmanns
MBMoritz Bock
Moritz Bock
JPJohanna Poschenrieder
Johanna Poschenrieder
SHStefan Haufe
Stefan Haufe
HGHubert A. Gasteiger
Hubert A. Gasteiger
While silicon can significantly enhance the energy density of lithium-ion battery (LiB) anodes, its volume expansion of +280% in the fully lithiated Li 15 Si 4 state and the resulting poor cycle life have limited its use in commercial applications. This study investigates a novel silicon-carbon (Si/C) composite anode material, composed of a carbon host structure infiltrated by silicon. The Si/C performance characteristics is compared with those of state-of-the-art graphite (Gra) and silicon-dominant (Si) anodes in full-cells with an NCA cathode. Full-cell charge and discharge rate tests show the same rate capability for the Si/C and Si anodes, which outperform the Gra anode. For a capacity retention of 80%, the cycle life of the full-cells with the Si/C anode of ∼650 cycles far exceeds the ∼200 cycles obtained with the Si anode but is still short of the ∼1000 cycles obtained with the graphite anode. The projected stack-level gravimetric/volumetric energy densities assuming commercial separator and current collector properties are ∼7%/∼16% higher for the Si/C compared to the graphite anode, approaching the ∼15%/∼20% energy density gains of the Si anodes. Consequently, this Si/C composite is a promising anode active material for LiBs, offering a combination of high energy density, rate capability, and lifetime.

22 December 2023 in ECS Meeting Abstracts
Verified
Journal Article
Closed access
LRLennart Reuter
Lennart Reuter
JDJonas L. S. Dickmanns
Jonas L. S. Dickmanns
SKSimon Kücher
Simon Kücher
SFSven Friedrich
Sven Friedrich
RMRobert Morasch
Robert Morasch
HGHubert Andreas Gasteiger
Hubert Andreas Gasteiger
Regarding the negative electrode, the most used electrode material in commercially available lithium-ion batteries (LIBs) up to the present day is graphite.1 Upon battery operation, an irreversible volume change in the microporous structure of the graphite electrode is detected. It is associated with the formation of the solid-electrolyte interphase (SEI) within the first cycles and an irreversible thickness increase of the electrode. Consequently, one observes a change in the electrode’s porosity after the initial formation cycles.2,3 Next to irreversible microstructure changes, one observes reversible changes in the microstructure associated with the intercalation of Li-ions into the host structure of the graphite particles upon charging the battery. The electrode particles expand during this process, increasing particle volume by ~13% when fully lithiated.4 In commercial LIBs, electrode materials, separators, and current collectors are tightly packed for a high volumetric energy density. This restricts the thickness expansion of the electrodes.5 Consequently, the graphite particles must expand into the internal pores of the electrodes, resulting in a decrease in the void volume of the porous network. Since the porous electrodes and the separator are filled with the electrolyte and the particle expansion of graphite is more significant than that of the active material in the positive electrode, one observes electrolyte motion in commercial LIBs during charge and discharge. It can be tracked by techniques requiring neutron beam facilities or expensive devices such as X-ray CT instruments.2,6 Recently, Aiken et al. developed a relatively simple apparatus to track the electrolyte motion by monitoring the changing moment of inertia of cylindrical cells during operation and simplifying the approach to study the discussed effect. In this study, we developed a method to track the reversible change of the microporous structure of an artificial graphite (MAGE-5, Hitachi, Japan) with an LP572 electrolyte (1 M LiPF6 in EC:EMC 7:3 w:w with 2 wt% VC, Gotion) during a charge and discharge cycle after formation employing electrochemical impedance spectroscopy (EIS) and operando dilatometry with both cell setups having a 1.5 bar cell compression Since the electrode’s microstructure is connected to the macroscopic properties using the MacMullin number of: NM=τ/ε=RIon·A·κ/d it correlates the porosity , electrodes thickness , ionic pore resistance , area of the electrode , conductivity of the electrolyte , and the tortuosity .8 Thus, we analyzed the change of the ionic pore resistance of graphite electrodes employing EIS in a MAGE//Li half-cell setup with a micro-reference electrode and a free-standing graphite electrode.Due to the particle expansion, we monitor an increase of the ionic pore resistance of up to 40% during charging, i.e., lithiation, of the graphite electrode. Next, we determined the SOC-dependent increase in thickness of the graphite electrode revealing a reversible thickness increase of 3%. Knowing the relation of porosity and tortuosity in a generalized Bruggeman form and using Equation 1 as described above with a constant electrode area and assuming a constant electrolyte conductivity , allowed us to extract the relative SOC-dependent decrease in porosity and void volume of the electrodes. At the end of the charge, both values decreased by approx. 10% and 9%, respectively, confirming the electrolyte repression from the graphite electrode. References: H. Zhang, Y. Yang, D. Ren, L. Wang, and X. He, Energy Storage Mater., 36, 147–170 (2021). T. Bond, R. Gauthier, A. Eldesoky, J. Harlow, and J. R. Dahn, J. Electrochem. Soc., 169, 020501 (2022). E. Moyassari, S. Kücher, N. M. Jobst, C.-C. Chang, S.-C. Hou, F. B. Spingler, M. Wohlfahrt-Mehrens, and A. Jossen, J. Electrochem. Soc., 170, 050528 (2023). S. Schweidler, L. De Biasi, G. Garcia, A. Mazilkin, P. Hartmann, T. Brezesinski, and J. Janek, ACS Appl. Energy Mater., 2, 7375–7384 (2019). K. W. Beard and T. B. Reddy, Linden’s Handbook of Batteries, Fifth Edition Copyright, p. 1–1401, New York, (2018). N. S. Nazer, M. Strobl, A. Kaestner, P. J. S. Vie, and V. A. Yartys, Electrochim. Acta, 427 (2022). C. P. Aiken, N. Kowalski, R. C. Fitzner, S. Trussler, J. E. Harlow, E. J. Butler, and J. R. Dahn, J. Electrochem. Soc., 170, 040529 (2023). J. Landesfeind, J. Hattendorff, A. Ehrl, W. A. Wall, and H. A. Gasteiger, J. Electrochem. Soc., 163, A1373–A1387 (2016). S. Solchenbach, D. Pritzl, E. J. Y. Kong, J. Landesfeind, and H. A. Gasteiger, J. Electrochem. Soc., 163, A2265–A2272 (2016). R. Morasch, B. Suthar, and H. A. Gasteiger, J. Electrochem. Soc., 167, 100540 (2020). Acknowledgements: The authors gratefully acknowledge funding from the German Federal Ministry of Economic Affairs and Climate Action through the project CAESAR (grant number 03EI3046F).